Gas regulator PC-MI氣體調節器PC-MI

Gas regulator PC-MI氣體調節器PC-MI

氣體調節器PC-MI

該控制器用于在微型培養箱中輸送混合氣體。連接到帶有

壓縮預混合（5%CO2/95%O2或任何其他，包括氮氣和低O2）氣體。輸出

直接連接到培養箱或加濕器的氣口。控制器調節輸出氣體流量

提供持續緩慢的氣體混合物流，以替換培養箱內的殘余氣體。可以使用

作為調節壓力的來源，用氣體使溶液飽和并控制溶液的流動。簡單的

使用。可調節以填充不同體積的培養箱。培養箱內二氧化碳平衡含量

不僅控制了細胞培養基的pH值，而且使氣體消耗降到低。如果使用源

對于純二氧化碳，需要一個不同的CO2-MI控制器。物品#：PC-MI

•輸入：大150PSI

•輸出：大750 sccm

•連接器：易于連接輸入，

5/32英寸。（4毫米）外徑管；10-32

帶螺紋；包括1/4英寸的接頭

O、 D.油管；

•指示器：數字顯示器

•功率：100-230VAC 35W

•控制：

輸入壓力調節器0-25PSI，

設定輸出%壓力，

關閉/打開輸入，

大流量可達750 sccm

二氧化碳控制器及附件

目錄號說明

微型培養箱用PC-MI氣體控制器

二氧化碳-500ML加濕器。

 Gas regulator PC-MI
The controller is used to deliver gas mixture inside miniature incubators. Connects to a cylinder with
compressed pre-mixed (5% CO2/95% O2 or any other, including nitrogen and low O2) gas. The output
connects directly to a gas port of the incubator or a humidifie . The controller regulates output gas flow to
provide continuous slow stream of gas mixture, to replace residual gases inside the incubator. Can be used
as a source of regulated pressure to saturate solutions with gases and to control flow of solutions. Simple
to use. Can be adjusted to fill incubators of di ferent volumes. Balanced CO2 content inside the incubator
not only controls pH of cell media, but also brings the gas consumption to the minimum. If using a source
of pure CO2, a different CO2-MI controller is required. Item#: PC-MI
• Inputs: max 150PSI
• Output: 750 sccm max
• Connectors: Easy-connect input,
5/32in. (4mm) O.D. tubing; 10-32
threaded; includes fitting for 1/4in
O.D. tubing;
• Indicators: digital display
• Power: 100-230VAC 35W
• Controls:
INPUT PRESSURE regulator 0-25PSI,
SET OUTPUT % pressure,
CLOSE/OPEN input,
FLOW rate up to 750 sccm max
CO2 Controller and Accessories
Catalog No. Description
PC-MI Gas Controller for Miniature Incubators
CO2-500ML Heated Humidifier.

 注：楊清辰發布