Cooler/Heater Unit微型冷卻/加熱裝置TC-RD

Cooler/Heater Unit微型冷卻/加熱裝置TC-RD

冷卻和加熱

微型灌注冷卻器/加熱器裝置TC-RD

將灌注液的溫度控制在0到100°C之間。一個小型加熱/冷卻元件

安裝在樣品旁邊的機械手上，通過

將溶液直接流到樣品上。

右邊是培養皿內溫度快速變化的例子。實驗條件：TC-RD

系統設置為0°C；使用另一個TC-1控制器和TC-PCP加熱將培養皿設置為30°C

階段；使用兩個流量控制CFPS-1U66裝置-一個用于通過PDI從培養皿中吸取溶液

插入盤中；和另一個CFPS-1U66用于冷卻TC-RD單元的散熱器；第三個CFPS-1U單元

用來給碟子加香；一個緩慢的溫度傳感器用來模擬

整盤；溶液應用點的實際溫度變化要快得多。項目#：TCRD

•尺寸：1 x 2 x 2英寸

•溫度穩定性：優于0.1°C，

內置傳感器

•散熱器：用于極低溫度的水冷

•反饋：可選級，或外部傳感器

（浴室）

Cooling & Heating
Miniature Perfusion Cooler/Heater Unit TC-RD
Controls temperature of perfusion solutions in the range from 0 to 100°C. A small heating/cooling element
is designed to mount on a manipulator next to your sample to provide fast temperature changes by
streaming the solution directly onto the sample.
On the right is an example of fast temperature change inside a petri dish. Experimental conditions: TC-RD
system was set at 0°C; the petri dish was set at 30°C using another TC-1 controller and TC-PCP heating
stage; two flow control CFPS-1U66 units were used - one for solution suction from the dish, through PDI
insert inside the dish; and another CFPS-1U66 to cool heat sink of TC-RD unit; the third CFPS-1U unit
was used to perfuse the dish; a slow temperature sensor was used to simulate temperature change in the
whole dish; the actual temperature change in the point of solution application is much faster. Item#: TCRD
• Dimensions: 1 x 2 x 2in
• Temperature stability: better than 0.1°C,
built-in sensor
• Heat Sink: water cooling for very low temperatures
• Feedback: Selectable Stage, or External sensor
(Bath)

 注：楊清辰發布